Entries by peiyuanxu93

Spring 2016 Pathfinder: Project Summary

By: Peiyuan Xu (Project Manager) Approved by Peiyuan Xu (Project Manager) Approved by Xiong Lee (System Engineer) Executive Summary Project Objectives The spring 2016 Pathfinder Rover was inspired by NASA’s MARs Exploration Rover-“Sojourner”. The profile for this semester’s project is to imitate the design of “Sojourner” Rover to prototype a new generation of Pathfinder Rover […]

Spring 2016 Pathfinder: Mission Profile and Project Objective Update

By: Peiyuan Xu (Project Manager) Mission Profile Update The team received the PDR debrief from meeting with the customer, student assistant and the president. One of the comments they had was that the mission profile was unclear. The team then develop a new mission profile which will clarify the confusion of the current one. Mission […]

Spring 2016 Pathfinder: Software Design

By: Juan Acosta (Electronics & Control – MCU Subsystem and Firmware)   Software System Block Diagram: The figure above depicts the software side of the Pathfinder. First, commands will be sent through Bluetooth and received through Serial communication ports on the Arduino Mega. Then the Command Handler will decode the telemetry packets being sent and appropriate […]

Spring 2016 Pathfinder: Design and Manufacturing – Chassis Selection Through the Iterative Design Loop

By: Lindsay Levanas (Design and Manufacturing) Introduction Although all previous posts regarding Spring 2016 Pathfinder’s chassis have focused on the rocker bogie suspension system design, the use of a Wild Thumper chassis was also considered and so it is worth documenting the iterative design loop that lead to the final product. This report will outline […]

Spring 2016 Pathfinder: Design and Manufacturing – PCB Layout

By: Lindsay Levanas (Design and Manufacturing) Introduction This report will serve to document how the Spring 2016 Pathfinder’s PCB layout was designed in EAGLE7.5.0 Light. Reference to the PCB schematic outlined in Spring 2016 Pathfinder: PCB System Schematic1 will be mentioned, as well as safety precautions from outside sources. Note that all components will be […]

Spring 2016 Pathfinder: PCB System Schematic

By: Juan Acosta (Electronics & Control – MCU Subsystem and Firmware) Tuong Vu     (Electronics & Control – Sensors, Actuators, and Power) Introduction: Project Pathfinder required the use of an Arduino Mega, VNH5019 motor shield, PCA9685 Servo PWM Controller, two HC-SR04 ultrasonic sensors, two servos, six DC motors, HC-06 Bluetooth Module, LED Headlights, and […]

Spring 2016 Pathfinder: Subsystem Design

By: Juan Acosta (E&C – MCU Subsystem & Firmware) Fritzing Diagram The fritzing schematic above depicts the circuit we used for testing the Wild Thumper Chassis’ motors, batteries, ultrasonic sensors, headlight L.E.D.s, servo driver along with servos, the motor shield along with the six motors driving the rover, and the Bluetooth module. Earlier testing showed us […]